Every Suorin Air owner has been in this situation at some point: your vape isn’t working, and you’re not sure what to do. You can take certain actions to fix your Air.Check to see if your Suorin Air is charged first if it isn’t hitting or shooting. Verify that your Air has a full charge. Purchase a new pod if cleaning is ineffective. You may need to purchase a new Air if purchasing a new pod doesn’t work either.
These actions appear straightforward, however, there is always a chance while cleaning your Suorin Air. I’ll go over each of the procedures above and demonstrate how to safely and properly clean your gadget in the sections below. So, check the steps to fix Suorin Air Plus not hitting.
- Ensure your Air is charged
Thankfully, the initial step is the simplest. Make sure your Suorin Air is charged before using it. Even though it’s so straightforward, this is one of the most frequent causes of Air not firing properly.Although it might seem obvious, if your Suorin’s battery is dead, it won’t hit at all. Before you begin anything else, ensure your Air is connected for at least a few minutes. The simplest solution will enable you to restart your Air.
- Clean Your Suorin Air thoroughly
Cleaning the Suorin air is the next, slightly more time-consuming process. Your Air must be taken out of its case as the first step in cleaning it. Pull the pod out, then push the electronics off the top with the tool or the pod. (See also my post on disassembling a Suorin Air.) Clean the airflow sensor, contact points (metal bits at the top), the rubber portion atop the contact points, and any other areas where you notice juice with a cotton swab.
To remove any residual juices from your pod, use a cotton swab or a tissue that has been folded up. Remove any leftover juice. You can also clean out the interior of your Suorin’s skin by inserting a tissue, the metal cover over the circuitry.Put the rubber piece on the electronics once you’re finished, and then cover them with the metal skin. By turning your pod back on, make sure your Air is operational. If it doesn’t, go on to learn about the subsequent action.
- Buy a new pod for your air
It could be necessary to purchase a new pod if cleaning every component of your Suorin Air doesn’t work. Some pods are defective when they leave the factory and will not function no matter what you do. Other times, something malfunctions inside the pod and prevents contact. Unfortunately, there isn’t much you can do to fix your faulty pod once you’ve reached this point.Fortunately, Suorin Air pods are reasonably priced and maybe had for as little as $4 each. Consider purchasing a new pod if your Air is still not connecting by this point.
- Purchase a new suorin air or another device
You might need to purchase a new Suorin if it still doesn’t fire or hit accurately at this stage. Suorin Airs are not meant to last forever and are designed to be relatively disposable.Over time, things degrade and break, juice seeps into the device, and if you’re anything like me, you drop things frequently. Simply told, your Suorin Air will eventually break, just like every other device you own.Your Air might need to be replaced. My point is that regardless of the device you currently own, you’ll ultimately need to buy a new one. Of course, if your Suorin is giving you too many problems, you can always get another vape.
Make Sure Your Air Is Charged
Fortunately, the first step is the easiest. You need to make sure that your Suorin Air is charged. As simple as this is, it’s one of the most common reasons for Air’s not firing properly.
This step sounds very obvious, but if your Suorin is out of battery, it isn’t going to hit at all. Make sure your Air is plugged in for at least a few minutes before you start to do anything else.
This This is the easiest fix and will help you get your Air working again.
Clean Your Suorin Air Thoroughly
See also:Â How to fix headphones where one side is quieter than the other?
The next, slightly longer step, is to clean your Suorin air. I’m going to give you a quick rundown here, but if you want to read how to do this more in-depth, check out my article on how to clean a Suorin Air V2.
The first step in cleaning your Air is to remove it from its case. Take out the pod and use the tool or the pod to push the electronics off the top. (Also check out my article on how to take apart a Suorin Air).
Take a cotton swab and gently clean your Suorin Air’s airflow sensor, contact points (metal bits at the top), the rubber piece on top of the contact points, and any other places where you see juice.
Use a cotton swab, or a rolled-up tissue to clean out any remaining juices from your pod. Clean up any remaining juice.
You can also clean out the inside of your Suorin’s skin (metal piece that surrounds the electronics) by inserting a tissue.
Once you’re done, place the rubber piece on the electronics and then put on the metal skin. Check that your Air works by putting your pod back on. If it doesn’t, keep reading to check out the next step.
Buy a New Pod for Your Air
If cleaning every part of your Suorin Air doesn’t work, you might just have to buy a new pod. Some pods come from the factory defective, and won’t work no matter what you try.
See also Do You Even (Face) Lift, Bro? Exercises for Your Cheeks and Jaw
See also: Air Pump Running But No Bubbles – How to Fix this?
Other times, something breaks inside the pod and makes it so that it won’t hit. Unfortunately, if you’re at this point, there’s not much you can do to fix your broken pod.
Fortunat4ly though, Suorin Air pods are cheap, and you can find them for as little as $4 apiece. If your Air still isn’t hitting by now, consider picking up a new pod.
Purchase a New Suorin Air or Other Device
At this point, if your Suorin still isn’t firing or hitting properly, you might need to buy a new one. Suorin Air’s are built to be somewhat disposable, and they’re definitely not going to last forever.
Things wear down and break over time, juice leaks into the device, and if you’re like me, you drop things a lot. To put it simply, your Suorin Air is going to break eventually, as is every other device that you own.
You may have to replace your Air. Of course, if your Suorin is giving you too many issues, you can always buy a different vape, but my point is that no matter which device you own, you’ll have to buy a new one eventually.
Give Your Suorin Some Time
This might sound stupid, but one thing that’s worked many times for me is to let your device sit for 30 minutes to an hour. Sometimes Suorin Air’s get too hot, and all they need is a little time to cool down.
Let it cool down for a few minutes before you buy a new one. It can be frustrating, but it’s worth the wait if it can fix your device.
Conclusion
Allowing your smartphone to sit for 30 to 60 minutes may sound silly, but I’ve found that it frequently works. Suorin Airs can overheat, and all they need is some time to cool down.Before you go out and get a new one, let it cool down for a while. While waiting can be annoying, it’s worth it if it fixes your gadget.